Door knob installation no screws

Notify me about replies to my post Post Reply. It can be a captive knob - permanently attached to the spindle or to the backplate a. A slight knock with a mullet would have moved it. See if you can snap a picture and post it here. It would make remote troubleshooting much easier.

Reply to homeowners. Anonymous Contact options for registered users. I prefer the brushed nickel or oil-rubbed bronze. The brushed nickel hides wear and tear very well.

And the oil-rubbed bronze just looks amazing. Reply to Anonymous. It must line-up with the holes in the latch assembly to function properly. When in place, position the opposite handle to secure the connection. Most models can be released with a small button on the base of the handle. Bringing our exciting adventure in door hardware installation to a close, just a few screws into the face place, and voila!

Securely closed doors and no more peeping toms. Disclosure: BobVila. Push on the tool. Step 4: Twist If It Resists. Twist the tool if the doorknob resists your efforts. Step 5: Remove the Rose. Step 6: Unscrew and Finish. Yohanka Alfocea Supporter. How do you bore a door? Once the center bit is through the door , stop. Bring the hole saw the other side of the door and finish the bore. Aythamy Gorecki Supporter. How do I change a door lock cylinder?

Remove the flat screw under the latch. Turn the key a quarter of the way. Pull on the key while pushing on the other side of the lock. Turn the key and slide the new cylinder into the hole.

Screw the flat screw back in. Test your key to make sure that it unlocks your door. Zoubaida Supporter. What is rekeying a lock? Rekeying locks.

Jadwiga Anker Beginner. How do you lock a door without drilling? If you need to lock the door from inside you could use a travel lock , these where designed to lock yourself into hotel rooms. The kind we used to sell went into the latch hole on the frame then you slide a catch down against the door , a bit like a garden tie and it will secure the door without drilling. Ask A Question. Co-authors: Updated On: 3rd March,