Raynor safety signal manual




















If it is unbalanced or binding, call a trained door systems technician. The model was created exclusively for commercial use. The opener system can perform not more than 12 cycles per hour or 50 cycles per day. The LED will flash when power is present.

Allow to cool and retry. If door closes, check accessory for proper wiring, polarity, connections or damage. Verify photoelectric sensors are not blocked and the sensing edge is not activated.

TTC will be re-enabled. Raynor FliteStar-7 is a residential garage door opener created for up to seven foot high doors. The opener provides additional safety due to the auxiliary entrapment protection system complementing the usual built-in safety reverse feature.

Symptom Probable solutions Operator runs from radio controls but not from push button Check connections at push button and operator terminals. Wire may be broken under staples or at terminals. Reverse wires at terminals 6 and 7 on the back of the opener. Remove wires from terminals 6 and 7, momentarily short across terminals 6 and 7, if operator runs then replace wall button.

Operator runs from push button but not from radio control Check battery in transmitter. Check receiver and transmitter code setting. Measure the voltage at terminals 1 and 3 on the 3 position terminal strip at the rear of the operator. With terminal 1 being negative and terminal 3 being positive, voltage should read between VDC. If it is necessary to return radio controls for repair, both transmitter and receiver must be returned.

Operator does not run from push button or radio control Illuminated wall-mounted push button lock switch is activated. Operator plugged into outlet. Burned out fuse or open breaker. Pull power plug and plug back in. Replace microprocessor control board. Operator stops functioning after repeated cycling Motor may be overheated.

Wait 20 minutes and try again. Less than 25 feet operating range from radio control Change battery in transmitter. Change location of transmitter in auto. Mount receiver to wall and wire to operator. If two or more operators are located within the same building, unplug all other operators and then test range. Faulty radio - return to distributor to repair or replace Motor hums but will not open or close the door Jammed or hard moving door. Disconnect door from operator and check door for correct balance and operating condition.

Do not disconnect an opened door, if door spring is broken the door may fall at a high speed and cause injury or property damage. Repairs and adjustments, especially to cable and spring assembly, can be hazardous and should be performed by qualified door installers only. Bad capacitor - Visually inspect capacitor Motor - Disconnect motor leads and test motor windings and thermal protector with ohmmeter.

Replace motor if windings or thermal protector are open. Motor must be cool to test. Check for proper electrical connections. NOTE: If operator is activated but does not open or close door, motor will shut off after approximately 25 seconds. Unwanted phantom operations Short in push button circuit. Check where stapled to wall or ceiling. Check connections at both ends of the wire. Can be caused by signal from another radio control in the area. Change frequency of radio control.

Door stops while it is opening Make sure there is no obstruction keeping the door from opening or closing, either during door travel or photo eye obstruction. Door reverses while it is closing Disconnect door arm and check door operation by hand.

Adjust force adjustment sensitivity. Turning the screw counter-clockwise will require more force to stop or reverse the door. A horizontal reinforcement brace should be long enough to be secured to two or three vertical Header They apply to one-piece doors also.

Mark either the left and right, or the top and bottom holes. Force adjustment settings door. NEVER use handle to pull garage door open or closed. If rope knot becomes untied, you could fall. If it is unbalanced or binding, call a trained door systems technician. My door will not close and the light bulbs blink on my motor unit: The safety reversing sensor must be connected and aligned correctly before the garage door opener will move in the down direction. Consult Diagnostic Chart below. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure.

Enables homeowner Includes visor clip. Print page 1 Print document 36 pages. Rename the bookmark. Raynor Garage Doors Project Gallery. National Garage Door Company A fresh new look for this home with a RockCreeke swing-out door in white with x-buck design. Shirey Overhead Doors, Inc. Aspen door in walnut, colonial recessed carriage house design with colonial windows, magnetic mission handles and straps compliment the look of this house perfectly. Automatic Door Specialists StyleView doors are the perfect touch for visibility and style!

Tri County Overhead Door Co. RockCreeke classic carriage house style with Sherwin-Williams paint. Montrose Garage Door. Raynor Corporate. This modern design with Raynor StyleView doors are a perfect combination. National Garage Door Company. This firehouse is looking sharp with AlumaView AV doors! Dutchess Overhead Doors. Take a look at these Raynor Aspen overhead doors with Sherwin-Williams paint to match the existing pass door.

A fresh new look for this home with a RockCreeke swing-out door in white with x-buck design. Automatic Door Specialists. StyleView doors are the perfect touch for visibility and style! Aspen AP with black EnduraCote and insulated prairie windows. Deluxe Doors. Aspen AP recessed grooved colonial garage door with Bershire ranch glass. What Our Customers Are Saying.

Montrose Garage Doors. Randy Oliver. Owner's Manual. Table of Contents. Previous Page. Next Page. River Road Dixon, Illinois www. Page 4: Planning Planning Identify the type and height of your garage door.

Survey your garage area to see if any of the conditions below apply to your installation. Additional materials may be required. Page 5: Carton Inventory Carton Inventory Your garage door opener is packaged in two cartons If anything is missing, carefully check the packing which contain the motor unit and all parts illustrated material. Parts may be stuck in the foam. Hardware for below.



0コメント

  • 1000 / 1000